The accuracy search can be configured using the following settings:

If the accuracy settings of the Creo part template differs from the accuracy of the part in PARTsolutions, it is possible that the part cannot be created in Creo.

Then the error message "Part could not be created" shows up.

Using the "AdjustAccuracyOnFail" setting, the geometry export can be configured in such a way that an automatic search for the appropriate accuracy settings of the part is conducted. If this setting is activated (AdjustAccuracyOnFail=1), an accuracy search is carried out if necessary. This concerns the calculation of accuracy of the sketches as well as the accuracy data of the entire part.

	Important
	With the activated accuracy search, the accuracy of a part may differ from the accuracy of the Creo part template. The actual accuracy must thus be checked manually.