In the submenu of
context menu command Copy to..., all
existing planes are shown. Elements which may be copied are listed
below.
In the
3D History, select one or multiple
points.
Open the
context menu on one of the selected points.
Click on
Copy to....
-> A list
of possible planes is shown, where the selection could be
inserted.
Click on the
desired plane.
Should elements
be selected which cannot be copied, a respective note is displayed.
Elements which can be copied
Sketches
Bases
(Base-Extrude, Base-Rotate)
Cuts
(Cut-Extrude, Cut-Rotate)
Planes
(offset and rotational planes)
Patterns
Pipe
runs
Texts
Sweeps (only
if the reference planes of both sketches are also copied)
Elements which cannot be copied
Blends
Drawings
Absolute
planes (inclusive XY, ZX, YZ)
Sweeps
(except if the reference planes of both sketches are also
selected)
![[Note]](https://webapi.partcommunity.com/service/help/latest/pages/cn/installation_ecatalogsolutions/doc/images/note.png) | Note |
|---|
It is
tried to keep dependency-tree structures alive after copy, if
necessary elements are selected as well. Selecting
a Base/Cut/Sweep will automatically copy its Sketch. Selecting
a Sketch, but not selecting its Base will only copy the
sketch.
|
