Chapter 20. V10.00 SP11
20.1. Remote Translation Service for Capvidia
Prev  Next

20.1. Remote Translation Service for Capvidia

As of V10 SP11 CAD data can be converted for a GeoSearch or LiveSearch via Remote Translation Service, on the fly centralized with Capvidia.[106]

This ensures that current CAD data and data already generated by Capvidia before have the same information content.

Overview graphic on Remote Translation Service

Overview graphic on Remote Translation Service

In order to set up the remote translation process the following steps are required:

  1. Precondition is availability of following licenses:

    • CADENAS license package for Capvidia operation

      PS/ADDON_IMPORTER_TOPOLOGY or PS/ADDON_IMPORTER_TOPOLOGY_GUI

    • Valid Capvidia license

  2. $CADENAS_SETUP/partsol.cfg

    Adjust partsol.cfg as the following figure shows.

    partsol.cfg

    partsol.cfg

  3. $CADENAS_USER/psolopt.cfg or $CADENAS_DEFAULTUSER/psolopt.cfg

    The described workflow requires the following setting: In block [CadAssistant], the key UseStepFormat has to be set on YES.

    (STL as format is not possible.)

  4. $CADENAS_SETUP/transremote.cfg

    Adjust transremote.cfg as the following figure shows.

    transremote.cfg

    transremote.cfg

  5. $CADENAS_SETUP/pappclient.cfg

    Install PARTapplicationServer (PAPPSERVER) via command line.

    $CADENAS\bin\x86\64\pappserver.exe –install

    Start PARTapplicationServer (PAPPSERVER) via command line.

    $CADENAS\bin\x86\64\pappserver.exe –start

    In pappclient.cfg, add the respective IP address.

  6. Install psworker Service

    1. Install psworker service via command line.

      Path..\bin\x86\64\psworker.exe –install

    2. Start psworker GUI vial command line.

      Path..\bin\x86\64\psworker.exe –gui

    3. Open psworker config via command line and adjust the settings as shown in the following figures.

      Path..\bin\x86\64\psworker.exe –config

      Tabbed page "General settings"

      Tabbed page "General settings"

      Tabbed page "Worker Configuration"

      Tabbed page "Worker Configuration"

    4. Start PARTsolutionsWorker via command line or TaskManager-Services

      Path..\bin\x86\64\psworker.exe –start

    5. PARTapplicationserver and PARTsolutionsWorker should be running now.

      Services "PAPPSERVER" and "PARTsolutionsWorker"

      Services "PAPPSERVER" and "PARTsolutionsWorker"



[106] 83071

Prev Up Next
Chapter 20. V10.00 SP11 Home Chapter 21. V10.00 SP9